Specifications Parameter Category Details Manufacturer & Series Schneider Electric, Modicon M580 (X80 I/O Platform) Complete Model Number BMXSDO0802 Module Type High-Speed Digital Output Module Rack Compatibility BMX X80 rack (supports hot-swap functionality) Number of Channels 8 Output Type Sourcing (PNP) – 24V DC positive switching. Rated Load Voltage 24V DC Nominal Output Current per Channel 0.5 A Maximum Total Current per Module 4 A (shared across all 8 channels) Peak Current per Channel 2 A for 100 ms Output Response Time < 100 µs (from order to physical state change) – This is a key high-speed characteristic. Switching Frequency Up to 10 kHz (pulse output capability) for specific channels/groups. Voltage Drop (On-state) Typically < 0.8 V at 0.5 A Leakage Current (Off-state) < 0.1 mA Short-Circuit Protection Yes, per channel. Electronic protection with diagnostic reporting. Isolation 500V AC between field side and logic/bus side. Diagnostics & Status • Per-channel diagnostics: Short-circuit, overload, wire break detection. • LED Indicators: Module status (RUN/ERR), power (PWR OK), and per-channel status (output ON). Communication Backplane X80 high-speed backplane with Ethernet for configuration and data exchange (DIO - Distributed I/O). Configuration Fully configurable within EcoStruxure Control Expert software. Parameters include filter times, behavior on CPU stop, and diagnostic settings. Hot-Swap Support Yes. Can be inserted or removed from the powered X80 rack without shutting down the system (adhering to proper procedures). Power Consumption From 5V backplane: Typically 150 mA From 24V field supply: Sum of all output load currents (max 4A). Connection Removable screw terminal block (front connector). Wire Gauge 0.5 to 2.5 mm² (AWG 20 to AWG 12) Operating Temperature 0°C to +60°C Storage Temperature -25°C to +70°C Protection Rating IP20 (for installation inside an enclosure) Standards IEC 61131, UL 508, CSA C22.2 No. 142.